802.3X Function Setting Jp2; Fx Duplex Setting Jp3; Jp1-Jp3 Factory Default Settings - KTI Networks KC-300DM Series Installation Manual

without storing the received packet on one port then forwarding to another port. The media converter operates
with the minimum latency.
Note:
1. In direct conversion, be sure both devices connected to the TP port and FX port have same duplex mode
for proper transmission.
2. In direct conversion, the 802.3x function is disabled and the media converter will not generate pause
frame, but just forwards the received pause frame directly from one port to another port.
3. In direct conversion, the media converter is not limited to the maximal length of the receiving packets.

3.1.2 802.3x Function Setting JP2

IEEE 802.3x function is the flow control method used for full duplex operation on TP port and FX port under
store and forward mode. This method uses pause frames for one port to stop further transmission from its link
partner.

3.1.3 FX Duplex Setting JP3

This setting is used to set the duplex mode of the FX port.

3.2 JP1-JP3 Factory Default Settings

The factory default settings for JP1, JP2, and JP3 are as follows:
JP1 Open Store-and-forward mode
JP2 Open 802.3x function is enabled
JP3 Open FX port full duplex
-19-