Table of Contents
Advertisement
Cleaning Foam Filter
12
Carefully remove foam filter.
Use a mild soap and water solution to wash foam filter
and rinse with clean water, and air dry before next use.
STORAGE
13
Wind hose around the motor head and put it on the
retaining bracket.
Floor Nozzle Attachments
14
The floor nozzle comes supplied with additional
attachments to ensure correct suction across different floor
surfaces and applications.
To remove the floor nozzle attachments, turn the floor tool
holder upside down.
Using a flathead screwdriver or other suitable tool, locate
the holding clips on each outer edge. Insert a flat edged
object directly next to the holding clip, between the insert
and the floor tool holder. Pry the attachment up from
underneath.
Insert the new attachments into the holder applying
downwards pressure.
The attachments can be used in three combinations.
Brush and Squeegee Combination: For use with mixture
of wet or dry liquids.
Dual Brush Combination: For use with dry materials or
carpeted floor surfaces.
Dual Squeegee Combination: For use on hard floor with
wet liquids.
NOTE: The textured side of the rubber squeegee must be
facing outwards
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing of as
waste. The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
SYMBOL
Safety Alert
Volts
Hertz
Alternating Current
Watts
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory requirements.
Please read the instructions carefully before
starting the machine.
Recycle
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Overload reset
Reference to the filter cleaning system
IPX4
Ingress Protection (Waterproof grade 4)
Vacuum cleaners of dust category M according to
IEC/EN 60335-2-69 for dry vacuuming of hazardous
dusts with an exposition limit value ≥0.1 mg/m
5
.
3
Advertisement
Table of Contents
