Checking Device Notifications; Turning On/Off Universal Contact Monitoring; Turning On/Off Condensation Monitoring; Device Setup - Siemens RDS110.R User Manual

9
Operating the thermostat from the mobile application

Checking device notifications

9.5 Checking device notifications

9.5.1 Turning on/off universal contact monitoring

9.5.2 Turning on/off condensation monitoring

9.6 Device setup

9.6.1 Configuring device locations

50 | 60
The mobile application notifies you of condensation risks and universal contact
state changes. If there are notifications, a red indication is displayed on the upper
right corner of the menu icon,
notification details.
By default, the mobile application can receive condensation notifications and
universal contact notifications. You can turn off the notifications as needed.
When a universal contact is configured as input in the local thermostat, use the
mobile application to see if it is switched on or off when the universal contact
monitoring function is on.
For more information on how to configure a universal contact input, see Changing
system setup [➙ 39].
Turn on/off universal contact monitoring
> "Setup".
1. Tap
2. Select the device for which you want to turn on or off universal contact
monitoring.
3. Drag the slider next to "Universal contact monitor" to the right or left to turn it on
or off. The function is on by default.
When a condensation monitor is configured as input in the local thermostat, the
condensation monitor detects condensation on chilled ceilings or at critical spots in
heating or ventilating plants. When there is a risk of condensation, the thermostat
sends a warning signal. The same signal is sent to the mobile application, provided
condensation monitoring is activated in the mobile application.
For more information on how to configure a condensation monitor input, see
Changing system setup [➙ 39].
Turn on/off condensation monitoring
> "Setup".
1. Tap
2. Select the device for which you want to turn on or off condensation monitoring.
3. Drag the slider next to "Condensation monitor" to the right or left to turn it on or
off. The function is on by default.
If multiple devices are added to an account, all devices are grouped in the default
location. Move some of them to a different location for better device management.
Move newly added devices to a different location
1. From the "Setup" page, tap the default location.
2. Tap the "Name" field and enter a new name for the new location. Note that this
field is editable only if more than one device is added to the default location.
3. Tap "Address".
. Expanding > "Notifications" displays
A6V11562455_en--_d