Kubota GL6000-AUS Operator's Manual page 34

22 OPERATING THE GENERATOR
B Stopping the Engine
1. Turn OFF all electrical device switches
for connected loads.
2. Turn OFF the circuit breakers.
3. Allow the engine to run with no load for
about 5 minutes before stopping the
engine completely.
4. Turn the main switch (key) to the "OFF"
position.
(1) Starter switch (Key)
5. Turn the fuel lever to the "CLOSE"
position.
(1) Fuel lever
(2) Fuel filter pot
(A) "OFF"
(B) "ON"
(C) "PREHEAT"
(D) "START"
(A) "CLOSE"
B If the Engine Fails to Stop in the Usual
Procedure (EMERGENCY STOP)
If the engine does not stop after turning the key switch
to "OFF" position, take the following (EMERGENCY
STOP) procedure.
CAUTION
To avoid personal injury:
A Keep your hands away from the
rotating parts, such as cooling fan
and V-belt.
injury may
manipulating the engine stop lever.
1. Open the door, using the door knob.
2. Turn the engine stop lever to "STOP" direction and
hold it for 5 to 10 seconds to shut off the engine.
(1) Engine stop lever
3. After stopping the engine, make sure that the door is
closed and the main switch (key) is at OFF.
4. The following causes are possible for such unusual
engine shut-off.
Pinpoint and correct the cause of trouble.
A Check for the stop solenoid.
A Check to see if the battery has discharged too
much or is in trouble.
A Check for disconnection of the battery terminals.
Otherwise personal
be caused when
(A) "START"
(B) "STOP"