Bissell SPINWAVE R5 Manual page 6

Mop Mode (continued)
Spot Mode
x2
1.
Place the robot in the center
of the area you want to clean.
To start cleaning, press the
play/pause button twice or
select "Spot" mode in the
BISSELL Connect App.
Maintaining the Mop Pads and Debris Trap
4.
Turn the power switch OFF.
Press the button on top of the
mop tank and pull to remove.
Place tank upside down on a
soft surface.
7.
Empty the dirt bin after
each use.
6 global.BISSELL.com
40 inches 40 inches
(1m) (1m)
2.
The robot will clean in a
square pattern covering an
area approximately 40" x 40"
for about 5 minutes. It will
beep when finished and return
to the dock.
5.
Firmly pull up on the mop
pads to remove. Replace mop
pads if damaged. Machine
wash separately in warm water.
8.
Push the tab on the top
of the mop tank to open and
empty dirt tank.
40 inches 40 inches
(1m) (1m)
3.
Use caution when walking
through the area as the floor
may be slippery. Allow to
remain wet for 5 minutes.
6.
To reattach, use the middle
hole on the pads to align with
the driver.
9.
Lift up on the filter cover on
top of the tank and remove the
filter. Brush off dust and debris
from the filter.