AS-9400BT
User Guide
2
Get started
This chapter provides information about how
to install, connect and use your scanner to do
your work, and how to charge and replace
your battery.
2.1 Charging and Installation
This section describes how to charge and set
up your scanner.
Charging Your Scanner
2.1.1
AS-9400BT contains a lithium-ion battery that is
partially charged at the factory. You might want to
charge it to full before your use it. The battery life
varies depending on usage.
You can charge the battery by connecting the cradle
with a USB (type C) cable to your computer, or with
a power supply, which charges the battery faster.
When your scanner is fully charged, your cradle's
LED turns to green.
Note: The percentage of power measured is for
reference only and the actual value may vary
depending on the battery power error.
Charging with
Power Supply
USB Cable (USB2.0)
USB Cable (USB3.0)
Caution Keep the charging pins dry
when you put your scanner on your cradle
to charge the battery. Wet charging pins
may cause water seeping into your cradle
and shortening its life.
Full Charge Time
4 hours
5 hours
4 hours
4