1
Step
Stem Installation
Loosen the bolt on the top of the stem to allow movement of the stem end.
Insert the stem into the headset and make sure the headset is over the safety line
of the stem. Using the provided Allen key, fasten the bolt on the top of the stem.
A
B
WARNING:
To prevent steering system damage
and possible loss of control, the "MIN-IN" (minimum insertion)
mark A on the stem must be below the top of the Locknut B .
WARNING:
Do not over-tighten the stem bolt. Over
tightering the stem bolt can damage the steering system and cause loss of
control.