Operation - BANWOOD CLASSIC Manual

How to assemble
the training wheel?
• Remove outside Alex Nuts
mudguard supports from both sides of
B
Alex by Spanner 15mm.
• Put the Alignment Tab
D
Wheel Leg , mudguard support,
spacer and an Axle Nut
of the rear wheel Alex.
• Fix the nuts with the spanner
15mm,make sure both training wheel
are the same distance from the ground.

OPERATION:

WARNING:
Before each ride, make sure both axle nuts are
tight. Also make sure both training wheels are the same distance from the
ground.
As your child's ability improves, you may raise and eventually remove the
training wheels.
Raising the training wheels little by little will help them learn to ride on the
bike's two wheels.
• To move the training wheels, loosen the axle nuts, slide the leg to the
correct position, and retighten the axle nuts.
• To remove the training wheels, remove the Axle Nuts and Trainings Whe-
el Legs. The reinstall Axle Nut over Alignment Tab and tighten securely.
A
and
C
,a Training
A
on each end
the rider or to others.
• Ride only on level areas.
• Do not ride on steep hills, uneven sidewalks, or near steps. The bicycle can
• Ride straight up and down sloped surface, because the bicycle can tip over
• Slow down at corners because you can not turn as queckly as bicycles
WARNING:
Make sure
the notched tab of the Alignment Tab C
is to the rear of the axle and in the slot of
the frame.
WARNING:
Failure to reinstall Axle Nuts can cause injury to
WARNING:
When riding with training wheels:
tip over if a training wheel goes off the edge of the riding surface.
when riding across sloped surfacer.
without training wheels.