Table of Contents
Advertisement
Troubleshooting
Problem
Vibrates excessively or
makes noise.
Stops.
The TUB CLEAN alarm does
not turn off.
44
English
Untitled-10 44
• Make sure the washing machine is set on a level floor. If the floor is
not level, use the levelling feet to adjust the washing machine.
• Make sure the washing machine is not contacting any other object.
• Make sure the laundry load is balanced.
• Make sure the laundry is spread evenly in the washing machine.
Spread out the laundry evenly and start again.
• Make sure the space around the washing machine is free of objects.
• Humming is produced normally during operation.
• Objects such as coins can cause noise. Remove these objects from
the washing machine after washing is complete.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door, and press or tap Hold to Start to start the washing
machine. For your safety, the washing machine will not spin unless
the door is closed.
• Before the washing machine starts to fill, it will make a series of
clicking noises to check the door lock and does a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly and the
washing machine may start.
• Make sure the inlet hose screens at the taps are not clogged.
Periodically clean the screens.
• This problem occurs temporarily due to low voltages, and will be
solved when power recovers.
• When the machine is diagnosed to be cleaned, the TUB CLEAN
indicator blinks for an hour. This recurs 6 consecutive times until you
run the TUB CLEAN cycle. This is normal, and not a system failure. To
keep the tub clean, it is recommended to run the cycle once every 1-3
months.
Action
2021-09-29
5:25:02
Advertisement
Table of Contents
