Frigidaire FGTR1837TD Use & Care Manual page 13

Table of Contents

Advertisement

To Connect Water Supply Line To Ice
Maker Inlet Valve
1. Disconnect refrigerator from electric power
source.
2. Place end of water supply line into sink or
bucket. Turn ON water supply and flush
supply line until water is clear. Turn OFF
water supply at shutoff valve.
3. Remove plastic cap from water valve inlet
and discard cap.
4. If you use copper tubing - Slide brass
compression nut, then ferrule (sleeve)
onto water supply line. Push water supply
line into water valve inlet as far as it
will go (¼ inch / 6.4 mm). Slide ferrule
(sleeve) into valve inlet and finger tighten
compression nut onto valve. Tighten
another half turn with a wrench; DO NOT
over tighten. See Figure 1.
If you use braided flexible stainless
steel tubing - The nut is already
assembled on the tubing. Slide nut onto
valve inlet and finger tighten nut onto
valve. Tighten another half turn with a
wrench; DO NOT over tighten. See Figure
2.
5. With steel clamp and screw, secure water
supply line (copper tubing only) to rear
panel of refrigerator as shown.
6. Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface.
7. Turn ON water supply at shutoff valve and
tighten any connections that leak.
8. Reconnect refrigerator to electrical power
source.
9. To turn ice maker on, lower wire signal
arm (side mounted) or set the ice maker's
On/Off power switch to the "I" position
(rear mounted).
NOTE
These instructions do not cover after market
ice maker installation. Instructions in after
market ice maker kit should be used.
CONNECTING THE WATER SUPPLY
Plastic Water
Tubing to Ice
Maker Fill
Tube
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 1
Plastic Water Tubing
to Ice Maker
Fill Tube
6 ft (1.8 Meters) Braided flexible
stainless steel water line from
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 2
Steel
Clamp
Brass
Compression
Ferrule
(Sleeve)
Copper
water line
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
Steel
Clamp
Braided
Flexible
Stainless
Water Line
Water Valve
Bracket
Valve Inlet
Water Valve
household water supply.
Nut
Steel
13

Advertisement

Table of Contents
loading

Table of Contents