Specific Service Instructions - JVC AV32L2EUGR Service Manual

AV32L2EUGR
AV32L2EUBL
AV32L2EUGY

SPECIFIC SERVICE INSTRUCTIONS

DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Unplug the power cord.
2. Remove the 11 screws marked
3. Withdraw the rear cover toward you.
REMOVING THE SIDE CONTROL JACK ASSEMBLY
" After removing the rear cover.
1. Remove the screw marked
2. While slightly raise the side control jack assembly, remove the 2
claws under the side control jack assembly.
3. Disconnect the connector "SR", "SL", "S", "F" and "K" as shown
in Fig 2.
REMOVING THE SIDE CONTROL PWB
" After removing the rear cover and side control jack assembly.
# # # #
1. Remove the 3 claws from back side of the side control jack
assembly as shown in Fig.2.
2. Pull out the SIDE CONTROL PWB.
REMOVING THE CHASSIS
" After removing the rear cover.
1. Slightly raise the both sides of the chassis by hand and remove
the two claws under the both sides of the chassis from the front
cabinet.
2. Withdraw the chassis backward.
(If necessary, take off the wire clamp, connectors etc.)
REMOVING THE SPEAKER BOX /SPEAKER
" After removing the rear cover.
1. Remove the 2 screws marked
NOTE : When removing the screws marked
assembly, remove the lower side screw first, and then
remove the upper one.
% % % %
2. Remove the 2 screws
& &
& &
3. Remove the 2 screws
4. Follow the same steps when removing the other hand speaker.
REMOVING THE AV TERMINAL BOARD
" After removing the rear cover.
1. Remove the 3 screws marked
2. Remove the 2 claws marked
in Fig. 3.
3. Remove the AV TERMINAL BOARD slightly in the direction of
)* *
* *
arrow as shown in Fig. 3.
6
! !
! !
as shown in the Fig. 1.
" as "
" "
shown in the Fig.1.
$ $
$ $
as shown in Fig. 1.
$ $ $ $
of the speaker box
attaching the speaker box.
attaching the speaker.
' ' ' '
as shown in the Fig. 1.
( ( ( (
under the CHASSIS as shown
CHECKING THE PW BOARD
To check the back side of the PW Board.
1) Pull out the chassis. (Refer to REMOVING THE CHASSIS).
2) Erect the chassis vertically so that you can easily check the
back side of the PW Board.
[CAUTION]
" When erecting the chassis, be careful so that there will be no
contacting with other PW Board.
" Before turning on power, make sure that the wire connector is
properly connected.
" When conducting a check with power supplied, be sure to confirm
that the CRT EARTH WIRE (BRAIDED ASS'Y) is connected to
the CRT SOCKET PW board.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire.
2. Never remove the cable tie used for tying the wires together.
Should it be inadvertently removed, be sure to tie the wires with
a new cable tie.
SiDE CONTROL JACK ASSEMBLY
Connector
SR
SL
S
F
K
AV TERMINAL
BOARD
No.51817
C
SIDE CONTROL
PWB
C
(Back view)
Fig. 2
I
H
H
AV SW PWB
Fig. 3