Advertisement
Quick Links
Advertisement
Related Manuals for Pyle SereneLife SLELT407
Summary of Contents for Pyle SereneLife SLELT407
- Page 1 SLELT407 40’’ Fitness Trampoline...
-
Page 2: Safety Instructions
www.PyleUSA.com SAFETY INSTRUCTIONS 1. Misuse and abuse of this trampoline is dangerous and can cause serious injuries. 2. All trampoline type exercises must be done with the Fitness Trampoline in the at position. The angle positions are for use with a medicine ball. 3. - Page 3 www.PyleUSA.com Parts List Parts Description Quantity Frame Jumping Mat Elastic Band Protective Padding Covering Cap Handrail Tube Kitbag...
-
Page 4: Assembly Instruction
www.PyleUSA.com Assembly Instruction WARNING 1. Keep children away from the trampoline during assembly. 2. Keep ngers away from the ends of the rails in the hinge area when unfolding the trampoline. The RAILS will try to spring back to the folded position if they are released before the snap into place. Serious injury can occur if ngers are caught between the ends of the RAILS. - Page 5 www.PyleUSA.com STEP 2 Remove the bracket pin from both ends of the trampoline, and place them to the side. STEP 3 Both persons press rails C and D, and using steady pressure, with hands open and ngers extended, use palm of hands to push rails A and B down until they touch the ground. Make sure that all joints are locked into place.
- Page 6 www.PyleUSA.com STEP 4 Insert the PIN back to the bracket to prevent rails from snapping together when you reach the at position STEP 5 Remove the covering cap on the threaded connector, and slide the protective padding (#4) over the unfolded frame.
- Page 7 www.PyleUSA.com STEP 6 Turn the frame upside down. Screw the six feet on to the threaded connectors on the underside of the frame. Turn the trampoline over and place it on its feet. STEP 7 Remove rubber “feet” from bottom of 2 legs, next place tube A over each leg, then replace rubber feet.
- Page 8 www.PyleUSA.com STEP 9 Lower top assembly into both A tubes until bottom hole in top assembly lines up with hole at top of each A tube. You may have to rotate each A tube for top assembly to t. Secure top assembly in place with E knob. STEP 10 Secure B knob to bottom of both A tubes.
-
Page 9: Care And Maintenance
www.PyleUSA.com STEP 11 To change height of handrail bar, remove E knob, move top assembly to desired height, then screw E knob back in place. There are 4 di erent height adjustments for the handrail. CARE AND MAINTENANCE Inspect the trampoline before each use and replace any worn, defective or missing parts. The following conditions could represent potential hazards: 1. - Page 10 www.PyleUSA.com WARNING IMPORTANT – PLEASE READ! WARNING – GENERAL SAFETY ADVICE • Please read the instructions before use and retain for future reference. • Ensure the trampoline has been assembled correctly, as per the instructions in the manual. • It is essential that the intended site for this trampoline is completely flat and level. If the ground is un-level this will cause movement in the frame and could cause stress on the joined sections.