www.PyleUSA.com SAFETY INSTRUCTIONS 1. Misuse and abuse of this trampoline is dangerous and can cause serious injuries. 2. All purchasers and all persons using the Trampoline must become familiar with the manufacturer's recommendations for proper assembly, use and care of the Fitness Trampoline. 3.
Page 3
www.PyleUSA.com Parts List Parts Description Quantity Frame Jumping Mat Spring Protective Padding Covering Cap Handrail Tube Kitbag...
www.PyleUSA.com BEFORE ASSEMBLY Check all springs BEFORE assembly. If any spring is not attached or damaged, pls follow below processes to attach or replace the spring. A. Find the open end of the SPRING (#3) and hook this end into the hole on the Rail. B.
Page 5
www.PyleUSA.com STEP 1 Lay the folding trampoline on the oor in its still folded position. Push out the ends so the trampoline forms a semi-circle. STEP 2 Remove the bracket pin from both ends of the trampoline, and place them to the side. STEP 3 Both persons press rails C and D, and using steady pressure, with hands open and ngers extended, use palm of hands to push rails A and B down until they touch the ground.
Page 6
www.PyleUSA.com STEP 4 Insert the PIN back to the bracket to prevent rails from snapping together when you reach the at position STEP 5 Remove the covering cap on the threaded connector, and slide the protective padding (#4) over the unfolded frame.
www.PyleUSA.com STEP 6 Turn the frame upside down. Screw the six feet on to the threaded connectors on the underside of the frame. Turn the trampoline over and place it on its feet. STEP 7 Insert the two handle support tube (#A) into trampoline base handle brackets. Attention: Bends of handle support face up and toward center of trampoline.
Page 8
www.PyleUSA.com WARNING IMPORTANT – PLEASE READ! WARNING – GENERAL SAFETY ADVICE • Please read the instructions before use and retain for future reference. • Ensure the trampoline has been assembled correctly, as per the instructions in the manual. • It is essential that the intended site for this trampoline is completely flat and level. If the ground is un-level this will cause movement in the frame and could cause stress on the joined sections.