Table of Contents
Advertisement
de
Program overview
0
settings
Program entry
position
After you have set a program, you will be shown the preset program settings. These
are recommendations for the set program and vary. You can adjust the program
settings to achieve an optimal washing process for your laundry.
You can find an overview of the possible program settings
at How you can adjust program settings at
Speed Perfect
Easy iron
prewash
Automatic stain Put the laundry items together as usual. Choose a program.
° / ¶ / º / ·
Temp. ° C
sling
Completed in
32
function
Wash / dry in less time with results that are comparable to the program set
without the Speed Perfect setting.
Note:
The energy consumption when washing and the water consumption when
drying is higher than with a program without the Speed Perfect setting.
Crease reduction through a special spin process with reduced spin
speed and subsequent loosening.
Note:
The laundry is more damp after the wash cycle than with programs without the
Easy Iron setting.
Additional prewash for washing heavily soiled laundry.
Note:
Divide the detergent required for the pre-wash and main wash into the compartment
I. and II on.
Select a type of stain (depending on the selected program). Start the program.
Olie / blood / red wine / grass
The device adjusts the average washing temperature, the drum movements
and the soaking time to the type of stain in question. With hot or cold water,
gentle or intensive washing and long or short soaking, an optimal washing
program for the respective type of stain is put together. In this way, stains
are optimally treated.
Adjusting the temperature.
Note:
The temperature that can be set depends on the program.
Adjusting the spin speed (in rpm (revolutions per minute).
Note:
The spin speed that can be set depends on the program.
setting 2:
The laundry is not spun at the end of the wash cycle and remains wet in the
drum. The water is only pumped out.
Before the program starts you can delay the end of the program in up to a maximum of 24
hours using the, Finished buttons.
The set number of hours, e.g. 8h, is shown in the display and counted down until the
program begins. After the program has started, the program duration is displayed.
Advertisement
Table of Contents
