Table of Contents
Advertisement
Operating Your Radio
Check Channel Number
Low Power Mode
Talk Button
Transmit (Tx) Icon
Receive (Rx) Icon
Standby/Receive
and Transmit
Transmit (Tx) Mode
Transmit (Tx) mode gives you the ability to interact with
safety services, other vessels and shore stations. When you
use this capability, be sure to follow the procedures and to
observe the courtesies that govern its use so everyone
benefits. See pages 14 through 23 to help you select the
proper channels.
To Transmit a Message:
1. Check to see that your radio is set to a proper
channel for the type of message you plan to send.
2. Toggle to the Low Power setting.
3. With the microphone about 5,1 cm [2 in.] from your
mouth, press and hold the Talk button and speak
into the microphone. The Transmit icon will appear
on the LCD.
4. Release the Talk button when you are finished
speaking. Your radio can only operate in either
Transmit (Tx) or Receive (Rx) mode at any given
time. You will not hear the response to your
message unless the Talk button is released. If the
Battery Power icon begins blinking on the LCD
when the Talk button is pressed, the radio will NOT
transmit.
NOTE
If the Talk button is held down for five (5) minutes,
the radio will automatically sound a series of beeps
and cease transmitting to prevent unwanted signal
generation and battery drain. As soon as the Talk
button is released, it can be pressed again to resume
transmission.
Nothing Comes Close to a Cobra
®
43
Advertisement
Table of Contents
