Table of Contents
Advertisement
Operating Your Radio
Setup Mode Programming
The following series of procedures is designed to allow you to set the programmable
features of your radio. Correctly following these steps results in a minimal amount
of radio setup programming time.
NOTE
When in the Setup mode, if you stop programming for longer than 15 seconds,
your entry will be saved and the radio will go back to the Marine Standby
mode. When you return to Setup mode and continue programming, you will see
the last "value" displayed. While in the Setup mode, you will not receive any
signal reception.
Marine (VHF) Mode Programming
Programming these features will allow you to customize certain features of this
radio to enhance your "On-Water" audio needs.
Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press
and hold the Call/Enter/Setup button for two (2) seconds to enter the programming
mode.
Set Channel Map
Active Channel Map Icon
Channel Up/Down Button
36 English
Setup Mode Programming
International/Canada/USA Channel Maps
Three (3) sets of VHF Channel Maps have been established
for marine use in the USA, Canada, and the rest of the world
(International). Most of the channels are the same for all
three (3) maps, but there are definite differences (see table
on pages 16 through 23). Your radio has all three (3) maps
built into it and will operate correctly in whichever area you
choose.
To Set Channel Map Operating Area:
1. The Channel Map mode is the first mode that
begins the Marine (VHF) Setup programming.
2. U, I and C will display, with the current setting (the
I icon is the default) flashing.
3. Press Channel Up/Down button to select the I, C or
U icon.
4. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
NOTE
One (1) or two(2) of the channel maps might have
been disabled for sales of this radio in some
countries.
•
Advertisement
Table of Contents
