Recalling Memory Locations; Using The Scan Function - Cobra microTALK FRS307 Operating Instructions Manual

O P E R AT I O N

Recalling Memory Locations

To recall a channel you have stored in a
memory location:
1. Press the MODE button until the Memory
icon and a memory location flashes.
MODE button
2. Select your desired
CHANNEL SELECT
memory location
button
by pushing the
CHANNEL SELECT
button up or down.
Press the LOCK
LOCK
button to enter
button
your selection. To
go on to the next
function without
selecting a memory
location, press the MODE button.
3. Repeat steps 1 and 2 to recall other
memory locations.

Using the Scan Function

Your microTALK ® radio can automatically
scan main channels (1-14), the privacy
codes (0-38) within one main channel,
or memory locations.
9
ENGLISH
To scan main channels:
1. Press the MODE button until the Scan icon
and main channel number flashes.
MODE button
2. Push the CHANNEL SELECT button up
or down and the unit will begin scanning
the main channels. (NOTE: The unit
"ignores" privacy codes while scanning
main channels.)
3. The radio will continue to scan all main
channels and stop if an incoming
transmission is detected. The unit will
remain on that channel for 10 seconds.
During that time you can:
a) Press and hold the TALK button and
talk. The radio will remain on that
channel and return to Standby mode.
b) Push the CHANNEL SELECT button
up or down to resume scanning main
channels.
c) Press the MODE button to proceed
to privacy code scanning (see following
page).
If you do not press any button within
10 seconds, the radio will automatically
resume scanning main channels.
ENGLISH
Using the Scan Function
(continued)
To scan privacy codes:
1. While in Standby mode, press the
CHANNEL SELECT button up or down to
choose the main channel you wish to scan.
CHANNEL SELECT
button
2. Press the MODE button until the Scan
icon and the privacy code number flashes.
MODE button
3. Push the CHANNEL SELECT button
up or down and the unit will begin
scanning privacy codes within the
main channel you selected.
4. The radio will continue to scan privacy
codes and stop if an incoming
transmission is detected. The unit will
remain on that code for 10 seconds.
During that time you can:
a) Press and hold the TALK button and talk.
The radio will remain on that channel and
privacy code, then return to Standby mode.
O P E R AT I O N
b) Push the CHANNEL SELECT button up or
down to resume scanning privacy codes.
c) Press the MODE button to proceed
to memory location scanning.
MODE button
CHANNEL SELECT
TALK button
button
If you do not press any button within
10 seconds, the radio will automatically
resume scanning privacy codes.
To scan memory locations:
1. Press the MODE button until the Scan icon,
Memory Location icon and memory
location number flashes.
MODE button
2. Push the CHANNEL SELECT button up or
down and the unit will begin scanning
memory locations.
CHANNEL
CHANNEL
DOWN
UP
10