Table of Contents
Advertisement
Secure unit to the dash using "U" bracket as shown.
The bracket is designed to secure the unit to a dash with a thickness of
2 mm. If your dash is thicker than 2 mm, the "U" bracket will be too
long. Simply place washers or spacers between the unit and the bracket
until you can tighten the wing nuts and secure the unit it place.
Once the unit is in place, you need to connect it to a power supply, to
the speaker (provided) and to the transducer. All of these elements are
described in the following paragraphs. Refer to the following
illustration as needed.
Flasher unit
(side view)
Power/trans-
ducer cable
LCF-1440 system components installed, including power connections.
Black wires
Speaker cable
Connect white wire
to "Lights" switch
on your boat's
instrument panel.
Pod transducer
Speaker
Black wire
3
2-amp fuse
Red wires
12 volt
battery
temp
sensor
Hide quick links:
Advertisement
Table of Contents
