Pre-Set Seat Width; Pre-Set Leg Lower Leg Length (Sedeo Pro Advanced) - Sunrise Medical QUICKIE Sedeo Pro Advanced Seating Manual

4.4 Pre-set seat width

Pre-set the armrest width:
NOTE: Only if the armrest width adjustment of Fig.4.11 & 4.12 is not
enough, the armrest axle can be moved out.
• Loosen the two screws (5.0mm Allen key) on the traversing tube as
shown in (Fig. 4.13 - A).
• Move the armrest receiver brackets to the desired position.
• Tighten the screws firmly prior to use.
CAUTION!
• Please check that the new arm rest position does not interfere with
any seat positioning.

4.5 Pre-set Leg Lower Leg Length (Sedeo Pro Advanced)

WARNING!
• Be aware of your environment to make sure you do not injure your
legs when Leg Rests are extended.
• Always ensure that the Leg Rests or footplates do not come into
contact with the casters before driving the wheelchair.
• Leg Rests are not to be used for lifting or carrying the wheelchair
under any circumstances.
• As with all moving parts be careful not to trap your fingers, (Fig. 4.14).
Pre-set footplate height and angle
The power centre mount footrest allows angle adjustment from 90° to
180° level to ground and a 185 mm powered length extension.
The left and right footplate can be adjusted by an angle of +/- 5.0°
and has a mechanical height range adjustment of 200 mm to 460 mm
measured from the footplate to the seat pan.
Pre-set footplate height:
• Undo the 2 bolts with a 5.0 mm Allen key, (A-Fig.4.15).
• Slide the footplate receiver up or down to the height required.
• Tighten the 2 bolts securely.
• Repeat for the other side.
Pre-set footplate angle:
• Flip up the footplate so that you can reach the angle setting screw,
(B-Fig.4.16).
• Use a 5.0 mm Allen key to adjust the bolt in or out depending on the
angle required.
WARNING!
• After adjustment and with the seat in its normal drive position: Ensure
there Is a gap of, (>25 mm.), between the floor and the footplate at all
times when manoeuvring the Footplate up or down.
• Perform this test with the user sitting in the chair loading the leg rest.
Using the chair with the leg rest set too low might result in personal
injury or damage to the wheelchair and its surroundings.
14
A A
1000 mm
1m
A
B
Sedeo Pro Advanced/Advanced UP Rev.A
Fig. 4.13
Fig. 4.14
Fig. 4.15
Fig. 4.16