Table of Contents
Advertisement
Installation
CAUTION:
For proper installation, it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC
standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does
not cover damage caused by improper installation remodeling or natural disasters. Failure to follow these recommendations
could result in voiding the warranty.
Setup Overview
1. Determine the installation location
CAUTION:
• Installing your LCD monitor must be done by a qualified
technician. Contact your supplier for more information.
• Moving or installing the LCD monitor must be done by two
or more people. Failure to follow this caution may result in
injury if the LCD monitor falls.
• Do not mount or operate the monitor upside down.
NOTE:
To avoid scratching the LCD panel, always place a soft
cloth, such as a blanket that is larger than the monitor's
screen area, on the table before laying the monitor face
down when installing the mounting accessories.
2. Install the remote control batteries
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
A
A. Press-and-hold the lock tab, then lift the battery
compartment cover from the remote control.
B. Align the batteries according to the (+) and (–) indications
inside the case.
C. Replace the cover.
NEC recommends the following battery use:
CAUTION:
Incorrect usage of batteries can result in leaks or bursting.
• Place "AAA" size batteries matching the (+) and (-) signs
on each battery to the (+) and (-) signs of the battery
compartment.
• Do not mix battery brands.
• Do not combine new and old batteries. This can shorten
battery life or cause liquid leakage of batteries.
• Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
• Do not touch exposed battery acid, it may injure your skin.
NOTE:
If you do not intend to use the Remote Control for a long
period of time, remove the batteries.
B
C
3. Connect external equipment
Refer to the user's manual of your equipment for further
information.
4. Connect the supplied power cord
• The equipment should be installed close to an easily
accessible power outlet.
• Fasten the power cord to the LCD monitor by attaching the
clamper.
• Fully insert the Plug into the power outlet socket.
A loose connection may cause image degradation.
WARNING:
• Please refer to the "Important Information" section of this
user's manual for proper selection of an AC power cord.
(Recommended Fasten Force: 29.5 - 49 N•cm)
English-12
Advertisement
Table of Contents
