Brother P-Touch D610BT User Manual page 144

Problem
follow the correct
procedure. (Windows)
• I cannot see my printer
listed in P-touch Editor
even though I have
installed the Printer
Driver. (Windows)
The ink ribbon is separated
from the ink roller.
Printed barcodes or QR
codes cannot be read.
I do not know the version
number of the firmware for
the Label Maker.
When the label is printed,
there is too much margin
(space) on both sides of the
text.
The font size cannot be
increased.
When multiple labels are
printed, the last label is cut
incorrectly.
I cannot update the printer's
firmware using the P-touch
Update Software, Transfer
Express, or Mac Update
Tool.
The Label Maker does not
operate normally.
Related Information
• Troubleshooting
Related Topics:
• Reset the Label Maker
• Set Language
• Check the Version Information
• Tape Cutting Options
PAGE 144 OF 154
Solution
2. Use the Printer Driver Uninstaller to remove the printer information.
3. Run the Printer Driver Installer again and follow the on-screen instructions to
proceed with the installation.
If the ink ribbon is damaged, replace the Tape Cassette. If it is not, leave the tape uncut
and carefully remove the Tape Cassette, and then wind the loose ink ribbon back onto
the spool.
• Change the tape. (Recommended: Black on white tape)
• Enlarge the barcodes or QR codes using your barcode application, if possible.
You can confirm the firmware version number and other information on the LCD. For
more information, see Related Topics.
• Select Small Margin, Chain, or No Cut options for smaller margins.
For more information, see Related Topics.
• After the last label prints, press
and then eject and cut the last label. Note that the Label Maker will feed
approximately 0.9" (23 mm) of tape before the next new label when you use this
method.
The font is already the maximum size for the width of the label, or the label length has
been set, so there is a limit on the font size to prevent exceeding the set length.
When Chain is enabled, feed the tape to eject the last printed label.
Restart the printer and then try to update the firmware again. Do not press any buttons
during the firmware update until the Home Screen is displayed automatically.
• Reset the internal memory to the factory settings. For more information, see Related
Topics.
• Disconnect the AC Adapter and remove the batteries for at least 10 minutes.
and simultaneously to feed the tape,
H-10159
1022 IH-10159VND
140