Table of Contents
Advertisement
Chapter 6. Configuration Menu
Dial Line/Auto Answer
A
A
UTO
NSWER
answering incoming calls with the CIC/DIC commands,
since the other settings for A
control of the answer function.
When V.25 dialing is selected, several recommended changes
are made automatically:
•
CTS is set to F
•
CD is set to N
•
DTR is set to I
•
DSR is set to O
These can be changed to other values if required by a particu-
lar application.
Dial Options/EIA-366 Timing
EIA-366 dialers can end a string of dialed numbers by sending
the end of number (EON) to alert the ISU 512e that the entire
number has been sent. Another method is to stop sending
numbers and allow the ISU to time out, then dial the number.
Use the following options to fine-tune the dialed number ter-
mination.
1
EON
SEC OR
2
EON
SEC OR
5
EON
SEC OR
(
)
DEF
6-8
should be disabled if V.25 bis is in control of
A
UTO
NSWER
RTS.
OLLOW
.
ORMAL
W
O
.
DLE
HEN
FF
I
T
.
FF
DLE OR
EST
The ISU 512e assumes the dial string is
fully entered if more than 1 second
elapses since input of the last digit, or the
unit receives the EON command.
The ISU 512e assumes the dial string is
fully entered if more than 2 seconds
elapse since input of the last digit, or the
unit receives the EON command.
The ISU 512e assumes the dial string is
fully entered if more than 5 seconds
elapse since input of the last digit, or an
EON command is received. This is the
factory default setting.
ISU 512e User Manual
will override V.25
61203086L1-1
Advertisement
Table of Contents
