Installation Instructions - Hamilton Beach HBFRF301-B Owner's Manual

Installation Instructions

Location
■ Two people should assist when moving the appliance.
■ Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft,
dry cloth and the inside with a luke warm wet cloth.
Place the appliance on a floor that is strong enough to support it when it is fully loaded.
■
Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this
■
can increase electrical consumption.
Do not use the appliance near water, for example in a wet basement or near a sink.
■
This appliance is intended for household use only. It is not designed for outside installation, including
■
anywhere that is not temperature controlled (garages, porches, vehicles, etc.).
Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This
■
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
This appliance is 52.6 cm (20.7 inches) wide by 83.3 cm (32.8 inches) high by 57.1 cm (22.48 inches)
■
deep. Make sure that you leave the minimum amount of space between the appliance and all surrounding
walls and vents.
Allow 12.7 cm (5 inches) of space between the back of the appliance and the wall. Allow 5 cm (2 inches)
■
between the sides and top of the appliance and any walls or counter tops.
This appliance is intended for free-standing installation only and is not intended to be built into a cabinet
■
or counter. Building in this appliance can cause it to malfunction.
.
4
4