Configuring Sinema Rc And Tia Cloud Connector On The Device - Siemens SIMATIC NET SCALANCE M80PB Getting Started

PROFIBUS connection
2.2 Remote service
2.2.3

Configuring SINEMA RC and TIA Cloud Connector on the device

Requirement
• SCALANCE M804PB has been created on the SINEMA RC.
• The SINEMA RC certificate is imported into the SCALANCE M804PB.
Procedure
1. Click "System > SINEMA RC" in the navigation area.
2. Configure the SINEMA RC with the following settings:
3. Select "Enable SINEMA RC" and click the "Set Values" button.
4. Click "System" > "Cloud Connector" in the navigation area.
5. Configure the TIA Portal Cloud Connector with the following settings:
6. Click the "Set Values" button.
28
SINEMA RC address
SINEMA RC port
Verification type:
CA certificate
Device ID
Device Password
Device Password Confirmation
Auto Firewall/NAT rules
Type of connection
Operation Enabled
Port 9023 (default port)
Protocol PROFIBUS
IP address of the SINEMA RC server
443
CA certificate
The imported CA certificate
The device ID is created automatically when the device is created
in the SINEMA RC server.
The password configured for access.
The firewall and NAT rules are created automatically for the VPN
connection. The connections between the configured exported
subnets and the subnets that can be reached via the SINEMA RC
server are allowed. The NAT settings are implemented as config-
ured in the SINEMA RC server.
You can enable SINEMA RC to access specific services of the de-
vice under "Security > Firewall > Predefined IPv4".
Permanent
Getting Started, 07/2020, C79000-G8976-C507-03
Cloud Connector