Voice/Tone Setting; Alert Audio Setting - Cobra ESD-9210 Operating Instructions Manual

3
O P E R AT I O N • S E T T I N G S

Voice/Tone Setting

You can set your ESD-9210 to sound alerts
with either a voice or a tone. You change
settings by using the MUTE button.
In Voice Alert™ mode you will first hear
several tones, then a voice message
announcing the type of signal detected,
followed by more tones. In Tone Alert
mode, you will hear the tones only.
The factory setting is Voice Alert™ mode .
Procedure
To change from While no signal is
being detected,
Voice Alert™
press and hold the
to Tone Alert
MUTE button for
two seconds.
To change from
While no signal is
being detected,
Tone Alert back
press and hold the
to Voice Alert™
MUTE button for
two seconds again.
12
MUTE button
Press and hold for 2 seconds
Tone Voice Visual Display
1 beep "tone alert" none
none "voice alert" none
VG-2 Alert ® Audio Setting
The ESD-9210 is undetectable by police
VG-2 detection devices, and will alert you
when such a device is in use near your
vehicle. During the alert, the unit continues
to detect other signals. You can choose
whether or not you want your unit to
sound VG-2 alerts.
The factory setting is VG-2 Audio On.
Procedure
To turn off While no signal is
being detected,
VG-2
press and hold
audio alert
the DIM button
for two seconds.
To turn on
While no signal is
being detected, press
VG-2
and hold the DIM
audio alert
button for two
seconds again.
O P E R AT I O N • S E T T I N G S
DIM button
Press and hold for 2 seconds
Tone Voice Visual Display
1 beep "VG-2 V
audio off" will blink
once in
the display
2 beeps "VG-2 V
audio on" will blink
twice in
the display.
X K Ka V S
3
13