KitchenAid KSDB900ESS2 Installation Instructions Manual page 14

4-Wire Connection: Power Supply Cord
Use this method for:
New branch-circuit installations (1996 NEC)
■
Mobile homes
■
Recreational vehicles
■
In an area where local codes prohibit grounding through the
■
neutral
1. Cut out and remove part of metal ground strap, as shown.
A. Metal ground strap
B. Discard
C. Ground-link screw
2. Use a Phillips screwdriver to remove the ground-link screw
from the back of the range. Save the ground-link screw and
the end of the ground link under the screw.
3. Feed the power supply cord through the strain relief on the
cord/conduit plate on bottom of range. Allow enough slack
toeasily attach the wiring to the terminal block.
A
C
A. Terminal block
B. Ground-link screw
C. UL listed strain relief
D. Power supply cord wires
14
4. Use a Phillips screwdriver to connect the green ground wire
5. Use ³⁄
A
B
C
6. Connect line 2 (red) and line 1 (black) wires to the outer
7. Firmly tighten hex nuts.
8. Tighten strain relief screws.
9. Replace lower access cover.
B
D
from the power supply cord to the range with the ground-
link screw and ground-link section. The ground wire must be
attached over the ground-link section.
" (1.0 cm) nut driver to connect the neutral (white) wire
8
to the center terminal block post with one of the 10-32 hex
nuts.
A
B
C
A. 10–32 hex nut
B. Ground-link screw
C. Line 2 (red) wire
terminal block posts with 10-32 hex nuts.
NOTE: For power supply cord replacement, use only a
power cord rated at 250 volts minimum, 40- or 50-amps
that is marked for use with nominal 1³⁄
connection opening, with ring terminals and marked for use
with ranges.
IMPORTANT: Verify the tightness of the hex nuts.
F
E
D
D. Green ground wire
E. Neutral (white) wire
F. Line 1 (black) wire
" (3.5 cm) diameter
8