Raise And Lower The Roll Bar - Ferris ISX3300 Series Operator's Manual

25
3. To open the transmission bypass valves rotate
the hydraulic actuator clockwise to the "bypass"
position" (marked "bypass" on the transmission) (B).
4. Disengage the parking brake. The zero-turn rider can now
be pushed by hand.
5. After moving the zero-turn rider, close the bypass valves
by rotating the hydraulic actuator counter-clockwise to
the "run" position (marked "run" on the transmission) (C).
Note: Both hydraulic actuators must be in the same position.

Raise and Lower the Roll Bar

WARNING
Avoid serious injury or death from roll over:
• Keep roll bar in the raised position and use the seat
belt.
• There is no roll over protection when the roll bar is
down.
• Lower the roll bar only when necessary and NEVER
remove it.
• Do NOT use seat belt when the roll bar is down.
• Raise the roll bar as soon as clearance permits.
• Do NOT jump off if the mower tips.
To lower the roll bar:
1. Pull the hair pin clips (A, Figure 26) out of the retainer
pins (B).
26
2. Rotate the retainer pins so that the handle of the pin is
pointing up (C).
3. Remove the retainer pins. You may need to push or pull
on the top loop (D) of the roll bar in order to pull the pins
out of the roll bar.
4. Lower the roll bar.
5. With the handles of the retainer pins pointing up, install
the retainer pins into the roll bar and secure the roll bar
into the down position.
6. Rotate the retainer pins so that the handle of the pin is
pointing down and then install the hair pin clips into the
retainer pins.
To raise the roll bar:
1. Pull the hair pin clips (A, Figure 26) out of the retainer
pins (B).
2. Rotate the retainer pins so that the handle of the pin is
pointing up (C).
3. Remove the retainer pins.
4. Raise the top loop (D) of the roll bar into position.
5. With the handles of the retainer pins pointing up, install
the retainer pins into the roll bar and secure the roll bar
into the raised position.
6. Rotate the retainer pins so that the handle of the pin is
pointing down and then install the hair pin clips into the
retainer pins.
27