Add/Remove Channels From Scan Memory; To Start Channel Scan - Uniden UH785 Series Owner's Manual

Operation

Add/Remove Channels from SCAN memory

1. Select which Scanning Mode you wish to use.
Turn the power off. Press and hold the [OS/GS] key while turning the
power on to change OS or GS Mode.
OS or GS icon appears on the display.
2. Press [ ] or [
3. Press and hold [MEM] for 1.5 secs. to store.
MEM icon appears and a short tone beep is heard.
4. To remove the channels from Memory:
Press and hold [MEM] for 1.5 seconds once more.
Two short tone beeps are heard and the MEM icon disappears.

To Start Channel SCAN

1. Press [SCAN] and the radio will begin scanning the channels that are
in the OS or GS memory - depending on which of these is currently
active. SCAN icon flashes during scanning.
Scan Direction
SCAN will begin scanning for active channels in a sequential order.
You can change the scan direction (increasing or decreasing channel
number) by pressing [
Drop-out delay
When SCAN finds a busy channel it pauses scan to receive the
signal. When the received signal stops, the radio waits for 3 seconds
for the return of the signal, otherwise, the radio resumes scanning.
UNIDEN UH785
] to select the channel you want to store.
] or [ ].
18
Handheld UHF-CB Transceiver