to allow operation in shallow water.
EWM00660
WARNING
Place the gear shift in neutral before
G
setting up for shallow water cruising.
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU28185
Procedure for power trim and tilt / power
tilt models
1.
Place the remote control lever / gear
shift lever in neutral.
N
ZMU04588
2.
Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch / power tilt switch.
UP
UP
DN
UP
3.
To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch / power tilt switch and
slowly tilt the outboard motor down.
EMU28192
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
Operation
ZMU01935
ZMU04602
UP
ZMU03527
40