Speedometer (Digital Type); Trim Meter (Digital Type) - Yamaha 150F Owner's Manual

Basic components
1
1. Overheat warning indicator
EMU26600

Speedometer (digital type)

This gauge shows the boat speed.
1. Speedometer
2. Fuel gauge
3. Trip meter/clock/voltmeter
4. Warning indicator(s)
NOTE:
After the main switch is first turned on, all
segments of the display come on as a test.
After a few seconds, the gauge will change
to normal operation. Watch the gauge when
turning on the main switch to make sure all
segments come on.
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
15
ting the selector switch on the back of the
gauge. See the illustration for settings.
ZMU01868
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
ZMU01869