Linksys WIP300 User Manual page 49

Wireless-G IP Phone
• Set up port forwarding on your router. You must specify that four port ranges be forwarded to the IP address of the IP Phone. These four port ranges
are as follows: 5060-5061 (UDP), 53-53 (UDP),
69-69 (UDP), and 10000-20000 (UDP).
• If you have a Linksys router, follow the instructions below to enable port forwarding on your router. If you have a non-Linksys router, refer to your
router's documentation for instructions.
1. Open a web browser on a computer that is connected to your router.
2. Access the Router's Web-based Utility by going to IP address of the Router (the default IP address is http://192.168.1.1).
3. You see the router's login screen. Leave the User Name field blank, then enter the Router's password (the default is admin) in the Password
field. Then click the OK button on the login screen.
4. Click on the Applications & Gaming tab, then click the Port Range Forwarding tab.
5. Enter a different Application name for each port range you must specify. Then enter the number or range of external port(s) used by the IP Phone.
6. Select the protocol you will be using, UDP.
7. Enter the IP address of the IP Phone. For example, if the IP Phone's IP address is 192.168.1.100, you would enter 100.
8. Repeat steps 5-7 until you have entered all four port ranges for the IP Phone.
Application
Internet phone 1
Internet phone 2
Internet phone 3
Internet phone 4
9. Click the Enable checkbox for the four port services you sepcified above.
10. When are finished configuring port forwarding, click the Save Settings button.
44
Start and End Protocol
5060 to 5061 UDP
53 to 53 UDP
69 to 69 UDP
10000 to 20000 UDP
IP Address
(IP address of IP Phone)
(IP address of IP Phone)
(IP address of IP Phone)
(IP address of IP Phone)
Enable
X
X
X
X
Appendix A: Troubleshooting
Common Problems and Solutions