Read This First; Specifications; Fitting Procedure - Panasonic BT-PRP17G Operating Instructions Manual

Protection panel
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
Read this fi rst !
Do not attach to monitors installed in high places.
The panel may cause injury should it fall off.
Only attach to designated monitors.
Otherwise this may cause injury or damage to equipment.
Do not use at a place subject to vibration.
If the protection panel is removed, this may cause bodily
injury.
Before attaching a fastener to a surface, wipe the
surface well to remove any dust or dirt.
If dust or dirt remains, the adhesiveness may not be
strong enough, and the panel may fall, causing bodily
injury or damage.
indicates safety instruction.
Specifi cations
Dimensions (W × H × D):
423 mm × 263.5 mm × 9 mm
(16
3
/
inches × 10
4
Weight: 410 g (0.9 lb)
<Components>
• Protection panel × 1

Fitting procedure

1
Affi x four fasteners along the length
of the monitor.
Use the four fasteners with bended corner. For
each fastener, remove its backing and align with
the ridgeline between the monitor and the LCD
panel, and then affi x the fastener. Affi x a total of
four fasteners, with two on the top and two on
the bottom.
Ridgeline
2
3
/
inches ×
3
/
inches)
8
8
• Fastener for fi tting × 6
2
Affi x two fasteners along the width of
the monitor.
Use the remaining two fasteners. For each
fastener, remove its backing and align with the
ridgeline between the monitor and the LCD
panel, and then affi x the fastener. Affi x a total of
two fasteners, with one on the left and one on
the right.
3
Attach the protection panel to the
monitor.
Place the protection panel with its fastener facing
the monitor. Move the protection panel so that its
upper part is below the tally lamp on the monitor,
and then attach the protection panel. Make sure
the position is correct, and then fi rmly press the
four sides of the protection panel.
After the installation, check once more to make
sure the protection panel is securely attached to
the display.
Cleaning
When the protection panel is dirty, use a soft cloth
to wipe it.
For stubborn stain, use a cloth dampened with mild
detergent diluted with water. Wring the cloth and then
wipe the panel. Finally, wipe with a dry, soft cloth.
Do not use thinner or benzene.
Ridgeline
Tally lamp

Advertisement

Table of Contents
loading

Table of Contents