Setting Up The Communications Port Using Windows Nt 4.0 - Lexmark T642 Technical Reference

11
12

Setting Up the Communications Port Using Windows NT 4.0

In your Windows NT 4.0 application:
1
2
3
4
5
6
7
8
9
Click OK.
Close all windows now that the port is set up.
On the Menu bar, click Start.
Click Settings.
Click Control Panel. The Control Panel screen appears.
Double-click the Ports icon. The Ports screen appears.
Select the communications port you want to configure.
Click the Settings button.
The Settings screen for this specific port displays. For example, if you select the
COM1 port, then the Settings for COM1 screen displays.
Fill out the fields for the following printer settings to make them match your
printer settings:
•
Baud Rate
•
Parity
•
Stop bits
•
Flow Control
Note: For Flow Control, select Hardware if you want DTR protocol or Xon/
Xoff for Xon/Xoff protocol.
Click OK.
Close all screens now that the port is set up.
8-3
Interfaces