Lcd Display Controls - Pittsburgh 93884 Owner's Manual & Safety Instructions

WARNING: The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It
must be understood by the operator that common sense
and caution are factors which cannot be built into this
product, but must be supplied by the operator.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
General Instructions for Use
WARNING! Only turn Laser on when tool is on
workpiece. Do not stare directly at the laser beam.
Do not aim the beam at any person or
object other than the workpiece.

LCD Display Controls

1. On/Off: Holding this button down for several
seconds turns the LCD display on or off.
The display will automatically shut off after
a period to conserve battery power.
2. Hold: This button keeps the same reading on
the display, even if the level's angle changes.
Everything on the display will flash except the
number while the reading is being held. Press
the button again to stop holding the reading.
3. 0% (percent): This button switches the
LCD display between displaying the angle
in degrees and displaying the angle as a
percent difference from 0° or 90°.
4. Calibrate (Zero Setting): This button toggles
between reading 0 at the current angle and reading
the actual angle. Press the "Calibrate" button once
to change the current reading to 0° or 0%. Press
the "Calibrate" button again and hold it to restore the
level to reading the actual angle. The level will reset
to reading the actual angle if it is switched off.
Note: Actual calibration of the level (changing the
actual angle setting) is not done by this button and
needs to be performed by a qualified technician.
Item 93884 For technical questions, please call 1-888-866-5797.
WARNING! Do not aim Laser at a workpiece
with a reflective surface, such as sheet metal.
Reflective sheet metal could direct
the beam back at the operator.
5. ))) Sound: This button toggles the sound. When
the sound is on, the level will beep once when it
measures any 10° increment and more than once
when it reads 0° or 90°. A symbol – ))) – will
appear above the decimal point on the display and
the unit will beep to indicate that the sound is on.
ON/OFF ON/OFF HOLD HOLD 0% CALIBRATE 0% CALIBRATE
) )
) )
) )
Page 3