Table of Contents
Advertisement
Wall Mounting Instructions
The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall. (Your Cobra Intenna is designed to
be used with any AT & T, GTE, local phone company or other wall-mounting
plates that can be purchased from most local electronics stores.)
¥
Run telephone cord through cord wrap channel on bottom of base. (As shown).
¥
Plug modular phone connector into telephone wall jack.
¥
Align mounting studs on the plate to the holes on the bottom of the
Intenna base; push base onto studs and slide down on the wall plate.
¥
Attach the power adapter to the POWER connection (on the base of the
phone) and plug into a household AC power outlet.
¥
To install directly on any wall, youÕll need to provide two screws and
wall anchors; follow these steps:
Ñ Drill two holes 3 1 / 4 " apart and insert the wall anchors.
Ñ Drive the screws into the anchors until the head of each screw is
protruding about 1/8" from the wall.
Ñ Align the holes in the cordless base over the screw heads; push base
in and slide down on screws (see diagram #3).
Ñ Plug modular phone connector into telephone wall jack; attach the
power adapter to the POWER connection (on the base of the phone)
and plug into to a household AC power outlet.
Modular Phone Jack
Diagram #2: In-
stallation on a
telephone wall-
mounting plate
Mounting Studs
Screw Heads
Diagram #3:
Installation
directly on a wall
Modular Phone Jack
7
Advertisement
Table of Contents
