Cross Reference Component Name, Order Number, Short Name; Introduction; Nyce 4000 System Housings - Bosch rexroth NYCe 4000 Hardware Manual

2/233

Introduction

1.3 Cross reference component name, order number, short
name
1.3.1 Introduction
1.3.2

NYCe 4000 system housings

Bosch Rexroth AG R911337671_Edition 18
NYCe 4000 Multi-axis motion control system Hardware Sys‐
Rexroth connection diagrams are only to be used for producing
installation connection diagrams. The machine manufacturer's
installation connection diagrams must be used for wiring the
installation!
● Route signal wires separately from the load resistance wires because of
the occurrence of interference.
● Feed analog signals (for example, command values, actual values) via
shielded lines.
● Do not connect mains, DC bus or power leads to low voltages or allow
them to come into contact.
● When carrying out a high voltage test or insulation withstand test on the
machine's electrical equipment, disconnect all connections to the units.
This protects the electronic components (permitted in accordance with
EN 60204-1).
WARNING
Do not plug in or unclamp live connections.
This chapter identifies the components of the NYCe 4000 system, the official
component name with its order number and the short name as used in the
user documentation. The short name is used in the user documentation to
improve readability.
Component name
NYS04.2-ST-01-ULNN-NY4013
NYS04.2-ST-02-ULNN-NY4023
NYS04.2-ST-03-ULNN-NY4033
NYS04.2-ST-04-ULNN-NY4043
NYS04.2-ST-05-ULNN-NY4053
NYS04.2-ST-02-LMSN-NY4074
NYS04.1-ST-01-LMS-SERCOS-NY4079
Tab. 1-1: Component name - order number and short name overview of
NYCe 4000 system housings
Plugging and unclamping live connections
can damage the controller.
Order number
R911172904
R911172905
R911172966
R911172906
R911172907
R911378504
R911378505
tem Manual
Short name
NY4013
NY4023
NY4033
NY4043
NY4053
NY4074
NY4079