Table of Contents
Advertisement
Installation manual
47
11.5 Setting the bolsters
Place each bolster (G) at its respective location (see drawing) and heave successively each bearing of the machine.
Verify the levels and place if necessary the wedges (C) between the bolster and the soles to stabilize the machine.
When the "trial " stalling is realized, apply obligatory the glue (type SILICOMET) on every bolster face and under the
soles of the machine (see drawing)
The indicated faces on the drawing must be aligned. Aplly equally glue to each face of the used wedges.
Put the machine in position and secure it with the bolts (F) without tighten .
Electrical safety device : As rubber is a very good electric insulating material, the earthing of the machine is
mandatory.
To displace the machine sealed with bolsters : You must introduce a flat chisel between the ground and the bol-
sters by heaving the machine; you have to remove them and avoid to pull off the ground.
12 Remove of the transport locks fitted
Important
Before putting the machine into service, it is compulsory to remove the 4 transport locks fitted.
To do so, remove the side casings, then the fixing screws of the transportation bridles (B), as well as the transporta-
tion bridle screws of the down casings (A).
Keep the transport locks fitted with their screws and bolts to be able to assemble them again in case you would need
to lift the machine.
Advertisement
Table of Contents
