Installing Two Air-Conditioners In The Same Room; Child Lock - Mitsubishi Heavy Industries SRK15ZTL-W User Manual

Installing two air-conditioners in the same room

■ When two air-conditioners are installed in the same room, use this setting when the two air-conditioners are not operated with one
remote control. Set the remote control and indoor unit.
Setting the remote control
1
Remove the cover and take out
batteries.
2
Disconnect the switching line next to
the battery with wire cutters.
Disconnect
3
Insert batteries.
Close the cover.

Child lock

■ This function locks the remote control operation to prevent an operation error.
Setting an indoor unit
1
Turn off the power source and turn it on after 1 minute.
2
Point the remote control (that was set according to the
procedure described on the left side) at the indoor unit
and send a signal by pressing the ACL switch on the
remote control.
Since the signal is sent in
about 6 seconds after the
ACL switch is pressed,
point the remote control
at the indoor unit for some
time.
3
Check that the reception buzzer sound "peep" is
emitted from the indoor unit.
At completion of the setting, the indoor unit emits a buzzer sound
"peep". (If no reception sound is emitted, start the setting from the
beginning again.)
1
Press the AIRFLOW L/R (LEFT/RIGHT) button for 3
seconds or more.
is displayed. When Child lock is set, only the ON/OFF button can be
operated.
How to cancel
Turn off the light by pressing the AIRFLOW L/R (LEFT/RIGHT) button for 3
seconds or more.
NOTE
 While Child lock is set, the settings of operation mode, temperature, fan
speed and airflow direction cannot be changed. To change the settings,
reset Child lock.
EN-11
Reception
peep