Installation; Hardware Installation - LevelOne CamCon FCS-1030 User Manual

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and "Administrator"
refers to the person who can configure the Network Camera and grant user access to the camera.

Hardware installation

Please verify you're your product package contains all the accessories listed in the foregoing
Package Contents. Depending on the user's application, an Ethernet cable may be needed. The
Ethernet cable should meet the specs of UTP Category 5 and not exceed 100 meters in length.
Upon powering up, the front blue LED will become lighted first and then the device will go through
booting process. During the booting process, both blue and red LEDs will be on and the Network
Camera will standby for getting IP address. After getting IP Address, the LED will blink blue every
second.
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the Network
Camera will try WLAN. During the searching and connecting process to the wireless access point
or station, the red LED of the Network Camera will flash every second. Until the Network Camera
connects to the other wireless device, the red LED will become lighted. Operating in either
network mode, the blue LED will flash every second as heartbeat to indicate alive.
*WLAN solution for WCS-2030 only
Connect the power adapter jack to the Network
Camera before plugging in to the power socket. This will
reduce the risk of accidental electric shock.
6