Errors Without Messages - Lenovo 3000 V100 0763 Supplementary Manual

Lenovo 3000 v100 0763: supplementary guide
Hide thumbs Also See for 3000 V100 0763:
Table of Contents

Advertisement

Solving computer problems
Code
Message
N/A
Operating system not
found
N/A*
Parity Check 1 nnnn
N/A*
Parity Check 2 nn
N/A
Press F1 to resume, F2 to
Setup, F3 for previous

Errors without messages

Problem:
When I turn on the machine, nothing appears on the screen and the
machine does not beep while starting up.
Note:
Solution:
12
Lenovo 3000 V100 Service and Troubleshooting Guide
Description
Verify the following:
The hard disk drive is correctly installed. A startable diskette
is in the diskette drive.
If you still see the same error message, check the boot
sequence using BIOS Utility.
Parity error found in the system bus. BIOS attempts to
locate the address and display i on the screen. If it cannot
locate the address, it displays ????. Parity is a method for
checking errors in binary data. A parity error indicates that
some data has been corrupted.
Parity error found in the I/O bus. BIOS attempts to locate
the address and display it on the screen. If it cannot locate
the address, it displays ????.
Displayed after any recoverable error message. Press F1 to
start the boot process or F2 to enter Setup and change the
settings. Press F3 to display the previous screen (usually an
initialization error of an Option ROM, i.e., an add-on card).
Write down and follow the information shown on the
screen.
v If you are not sure whether you heard any beeps, turn off the
computer; then turn it on again, and listen again.
v If you are using an external monitor, refer to "Computer screen
problems" on page 17
→ If a user password is set, press any key to display the user password
prompt, and then type the correct password and press Enter.
If the user password prompt does not appear, the brightness level
might be set to minimum brightness. Adjust the brightness level by
pressing Fn+F11.
If the screen still remains blank, make sure that:
– The battery is installed correctly.
– The ac adapter is connected to the computer and the power cord is
plugged into a working electrical outlet.

Advertisement

Table of Contents
loading

This manual is also suitable for:

3000 v100

Table of Contents