3. Use the blue handle to pivot the hard disk drive and bracket upward, slide the
Figure 21. Removing the hard disk drive
4. Disconnect the signal and power cables from the rear of the hard disk drive.
5. To install a new hard disk drive into the blue bracket, flex the bracket and align
Figure 22. Aligning the pins with the holes in the hard disk drive
hard disk drive to the left until it is free from the retaining clips in the bottom
of the chassis, and then completely remove it from the chassis.
pin 1 , pin 2 , pin 3 , and pin 4 on the bracket with the holes in the hard
disk drive. Do not touch the circuit board 5 on the bottom of the hard disk
drive.
Chapter 2. Installing options and replacing hardware
27