Selecting A Startup Device; Selecting A Temporary Startup Device; Selecting Or Changing The Startup Device Sequence - Lenovo ThinkCentre A57 9702 User Manual

3. Select Security Profile by Device.
4. Select the desired devices and settings and press Enter.
5. Return to the Setup Utility program menu and select Exit and then Save

Selecting a startup device

If your computer does not start up from a device such as the CD-ROM, diskette, or
hard disk drive as expected, use one of the following procedures to select a startup
device.

Selecting a temporary startup device

Use this procedure to startup from any boot device.
Note: Not all CDs, hard disk drives, and diskettes are bootable.
1. Turn off your computer.
2. Press and hold the F12 key then turn on the computer. When the Startup
3. Select the desired startup device from the Startup Device Menu and press
Note: Selecting a startup device from the Startup Device menu does not

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the
following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. Select Startup.
3. Select Startup Sequence. See the information displayed on the right side of the
4. Select the devices for the Primary Startup Sequence, the Automatic Startup
5. Select Exit from the Setup Utility menu and then Save Settings or Save and
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.
Settings or Save and exit the Setup Utility.
Note: If you do not want to save the settings, select Exit the Setup Utility
without saving.
Device Menu appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
Enter to begin.
permanently change the startup sequence.
page 31).
screen.
Sequence, and the Error Startup Sequence.
exit the Setup Utility.
Chapter 5. Using the Setup Utility
33