Table of Contents
Advertisement
The following illustration shows the locations of parts on the system board for
some models.
Installing memory
Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing memory modules, the following rules apply:
v Use 2.5 V, 184-pin double data rate synchronous dynamic random access
v Use 128 MB, 256 MB, 512 MB or 1.0 GB memory modules in any combination.
Note: Only DDR SDRAM DIMMs can be used.
To install a memory module:
1. Removing the cover. See "Removing the cover" on page 11.
2. Locate the memory connectors. See "Identifying parts on the system board" on
14
User Guide
1 Microprocessor and heat sink
2 Microprocessor fan connector
3 Memory connector 1
4 Memory connector 2
5 Power connector
6 Diskette drive connector
7 Primary IDE connector
8 Secondary IDE connector
9 Fan connector
memory (DDR SDRAM).
page 12.
10 Front panel connector
11 Power LED connector
12 Clear CMOS/Recovery jumper
Note: This part may be a two-pin header.
13 Battery
14 PCI connectors
15 CD-ROM in connector
16 AGP connector
17 Front audio connector
18 12v power connector
Advertisement
Table of Contents
