Table of Contents
Advertisement
About this guide
Rack options installation guide
This installation guide includes the instructions for installing rack option kits that are compatible with the HPE Advanced G2
Series and HPE Enterprise G2 Series racks.
For more information, see the HPE Advanced G2 Series Racks User Guide or the HPE Enterprise G2 Series Racks User Guide
on the Hewlett Packard Enterprise website.
Important safety information
WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
•
The front and rear leveling feet are extended to the floor.
•
The full weight of the rack rests on the rear leveling feet and front stabilizer feet.
WARNING: To reduce the risk of personal injury or damage to the rack and equipment, position and secure the racks
according to the instructions in this guide. Failure to do so could result in an unstable installation.
WARNING: Components can be very heavy. To reduce the risk of personal injury or damage to the equipment:
•
Remove all pluggable power supplies and modules to reduce the weight of the product before lifting it.
•
Observe local occupational health and safety requirements and guidelines for manual material handling.
•
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened
to the rails. When the component weighs more than 22.5 kg (50 lb), at least two people must lift the component into
the rack together. If the component is loaded into the rack above chest level, a third person must assist in aligning
the rails while the other two support the component.
•
Use caution when installing the component in or removing the component from the rack; it is unstable when not
fastened to the rails.
7
About this guide
Advertisement
Table of Contents
