Controls/Tracer Td7 Operator Interface - Trane CITY RTSF Series Manual

Controls/Tracer TD7 Operator Interface

Controls Overview
The unit uses the following control/interface components:
• Tracer™ UC800 Controller
• Tracer TD7 Operator Interface
Communication Interfaces
There are four connections on the UC800 that support the communication interface. See User Guide to locate the
following ports: "Wiring and Ports Description" section.
• BACnet MS/TP
• BACnet IP
• Modbus Slave
• LonTalk using LCI-C (from the IPC3 bus)
See chiller User Guide for information on communication interface.
Tracer TD7 Operator Interface
Operator Interface
Information is tailored to operators, service technicians and owners. When operating a chiller, there is specifi c
information you need on a day-to-day basis, like setpoints, limits, diagnostic information, and reports. Day-to-
day operational information is presented at the display. Logically organized groups of information-chiller mode of
operation, active diagnostics, settings and reports put information conveniently at your fi ngertips.
Tracer™ TU
The TD7 operator interface allows for daily operation tasks and setpoint changes. However to adequately service
chiller, Tracer™ TU service tool is required (Non-Trane personnel, contact your local Trane offi ce for software purchase
information). Tracer TU adds a level of sophistication that improves service technician effectiveness and minimizes
chiller downtime. This portable PC-based service-tool software supports service and maintenance tasks.
RLC-SVX023B-GB 33