Product Lineup - Fujitsu MB90M405 Hardware Manual

1.3 Product Lineup

Table 1-1 lists the Monolith (MB90M405) series product lineup. Functions other than the ROM/RAM capacity
are shared.
Product name
Classification
ROM capacity
RAM capacity
Count of basic instructions: 351
Minimum instruction execution time:
CPU Function
Addressing types: 23
Program patch function: 2-address pointer
Maximum memory space: 16 Mbytes
Port I/O port (CMOS)
60 FL output pins can be used (Under LED control, 43 FL output pins and 17 LED
control pins are required).
FL Controller
Can also be used as the clock-synchronous method extended I/O serial.
Serial I/O (UART) A dedicated baud rate generator is built-in.
Four channels are built-in (two channels also serve as UART channels).
16-bit reload timer 16-bit reload timer operation (Toggle output or one-shot output can be selected.)
An event count function can be selected. Three channels are built-in.
16-bit free-run timer 16-bit output compare x 1 channel (for clearing free-run timer)
16-bit input capture x 2 channels
8-/10-bit A/D 8-/10-bit resolution x 16 channels (input multiplex)
converter
Minimum conversion time: 6.2 µs (at internal operation of 16 MHz)
Timer clock divider The external input clock can be divided and output to the outside.
Clock division rates: 16, 32, 64, or 128 (programmable)
External interrupt Four independent channels (also serve for A/D input)
Interrupt factor: L → H edge, H → L edge, L level, or H level
Low power Sleep mode, stop mode, CPU intermittent mode, or pseudo-timer mode
consumption mode
Process
Package
Operating voltage
GENERAL
Table 1-1 MB90M405 Series Product Lineup
MB90MV405 MB90MF408
Evaluate Flash Type ROM
Not provided
4 Kbytes
Enables FL driver control and LED driver control can be performed.
Under FL driver control, the dimmer can be set for both digits and segments.
PGA256
3.3 V ±0.3 V(16.8 MHz: 4.2 MHz multiplied by 4)
MB90M408
Mass-produced product (mask ROM)
128 Kbytes
4 Kbytes
59.5 ns (at original oscillation of 4.2 MHz, with
PLL clock generated by multiplying original
oscillation by 4)
26 pins (all of 26 pins also serve as resource pins)
CMOS
QFP-100 (0.65 mm pitch)
1-5
MB90M407
96 Kbytes
4 Kbytes