Properties; Initialising - La Crosse Technology WS-2510 Operating Instructions Manual

Properties

Notice:
The adjustment of the properties is only possible on the PC Interface WS-2510
PC. The base station WS-2510 is working with a fixed interval time (15 min.). The
adjustment of the sensor version and the addresses for the sensors is made
directly at the base station of the WS-2510. Therefore, the initialisation menu
can only be called if the PC Interface WS-2510 PC is connected.
Initialisation
After the batteries have been inserted and the interface's indoor initialisation
phase is over, the interface will be set to the following standard parameters:
Address of the indoor sensor:
Address of the wind sensor:
Address of the brightness sensor: 7
Address of the rain sensor:
Sensor version:
Interval time:
If you wish to change these parameters, you should select the "Initialisation"
option. Here you can define the addresses of the above sensors, as well as the
sensor version and the interval time for the sensor query.
Sensor addresses
You can find instructions for this in the "Starting operation of the sensors" chap-
ter.
Sensor version
For details on determining the sensor version, please read the chapter entitled
"Preparation of the radio interface".
46
7
7
7
1.2
5 minutes
The initialisation menu for the
radio interface