Panasonic WX-ST600P Operating Instructions Manual page 17

l E xternal input connector
Transmits the audio from the external device to the receiver (page 32).
Audio is not sent from the gooseneck microphone (WX-ST600P) or built-in microphone
(WX-ST700P) when an external device is connected to this connector. Stereo audio will
become monaural.
m B attery cover
Press and slide to remove the battery cover.
n P airing button [REG] (inside the battery cover)
This button controls the pairing between the microphone and the receiver.
● Pairing : While the power switch is set to ON, keep the [REG] button pressed for more
than two seconds to enter pairing mode (page 24).
● Pairing confirmation
: Press the [REG] button once while the power switch is set to ON to enter
pairing confirmation mode (page 28). The pairing confirmation mode lasts
for five seconds on both the microphone and the receiver, after which both
will go back to their normal operation mode.
o I nput level meter setting switch [INPUT LEVEL METER OFF/ON]
(inside the battery cover)
Switches the input level meter ( 8 ) ON/OFF.
[INPUT LEVEL METER OFF] : Input level meter is not shown.
[INPUT LEVEL METER ON] : Input level meter is shown. (factory default)
p P TT setting switch [PTT OFF/ON] (inside the battery cover)
Switches between talk lock and push to talk.
[PTT OFF] : Talk lock (factory default)
[PTT ON] : Push to talk
q S ensitivity setting switch [SENS L/H] (inside the battery cover)
Sets the sensitivity to audio from for the microphone unit (page 22).
[SENS L] : Low sensitivity (factory default)
[SENS H] : High sensitivity
17