3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes.
See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
3.4.1
Mechanical specifications
Refer to Figure 4 for detailed mounting configuration dimensions. See Section 3.4, "Drive mounting. "
Weight:
1.43 lb
These dimensions conform to the Small Form Factor Standard documented in
Note
SFF-8301 and SFF-8323, found at
Figure 4.
Mounting configuration dimensions (10TB)
The image is for mechanical dimension reference only and may not represent the actual drive.
Note
Seagate IronWolf Serial ATA Product Manual, Rev. E
650 g
www.sffcommittee.org
22