Route Mode Configuration; Configure Pppoe Wan Connection For Internet In Route Mode - Zoom Realtek Series User Manual

Table of Contents

6.1 Route Mode Configuration

1. Login ONU WEB, select Network -> WAN->WAN, and then there are some

parameters for us to configure as follows:

【Enable Vlan】We can set this option according to your network plan. If there is

vlan in the network for internet, we have to check 'Enable VLAN ' option. If not, we needn't

check this option, which will be VLAN transparent mode.

【Vlan ID】Configure this option according to our network plan.

【802.1p_Mark】Set the priority of vlan, The same as "enable Vlan", depending on

the network vlan planning to configure. The default priority is 0.

【Service Type】Choose PPPOE.

【Eable NAPT】 Check ' NAPT ' feature； NAPT is mainly used for address translation

function of local network and external network. The default is checked enable status. If you

do not check this option, maybe you can't surf the internet.

【Admin Status】default is Enable.

【Connect Type】Choose Internet.

【MTU】The default is 1492; we have to change to lower MTU, such as 1400, if we

can ping the DNS but not access the website via WEB broswer.

【IP Protocol】Select 'Ipv4'; If there is Ipv6 in the network, we can select ' Ipv4/Ipv6 ' .

【User Name】Type PPPoE account, normally offered by ISP, for Internet；

【Password】Type PPPoE password, normally offered by ISP, for Internet；

【Bind port】Bind the physical ports (Lan port 1-4 and wireless) with PPPoE WAN

connection.

Note:

By default, all LAN ports and WIFI data are not bound by this WAN connection

(a LAN and WIFI SSID can only be bound to a WAN connection at the same time).

Table of Contents